Categories

Hot Products

News

Introduction Of Speed Reducer Structure
Sep 03, 2018

     The structure and weight of the reducer is very much, today China Starred-River Machine on the common speed reducer to do a simple introduction.

      The speed reducer consists of a box body, an oil plug (screw plug), an oil gauge, a peep hole, an air hole, a cover opening screw, a positioning pin, a hook, a ring screw or a lug, and a stop washer and a shaft end gear ring.


The detailed structures are as belows:

      1. Reducer box 

     The box is one of the main parts of the reducer, in order to disassemble and assemble conveniently, often use fractional structure, and use bolts to lower the box seat and cover into a whole.

      2. Oil plug (screw plug)

     Set in the lower side of the box seat, use and change oil, remove oil dirt and remove oil from the reducer cavity when discharging oil.

      3. Dipstick

      The height of the oil surface used to check the lubricating oil in the reducer.

      4. Peephole

      Set at the top of the box cover, with observation, check gear meshing and lubrication, lubricating oil is also injected into the hole.

      5. Ventilation hole

     After each working period of time, the temperature will gradually increase, which will cause the expansion of air in the box, oil vapor from the hole in time to discharge, so that the pressure inside and outside the box is consistent, so as to ensure that the box seal is not destroyed.

      6. Opening Screw

     Sealing glue is usually coated on the joint surface of the flange connecting the box cover and the box seat. It is difficult to remove the box cover. Only by screwing the screw can the box cover be lifted.

      7. Positioning pin

      In order to ensure the accuracy of boring and assembling the box bearing seat hole, the box cover and box seat should be positioned with two tapered pins and fastened with connecting bolts before boring the bearing hole.

      8. Hook

       Use and hoist the entire reducer, and the box seat into one.

      9. Ring screw or lug

       Connect the box cover with thread, only for use in the process of production or disassembly.

     10. Stop washer and shaft end gear ring: make coupling and axle end drive wheel positioned.

    *For more detailed parameters,size,price.Pls contact the Hangzhou Starred-River Machinery Co., Ltd.

   Tel:+86-571-89988766

     E-mail:802@china-sr.com

     Website:http://www.srgearboxes.com

     Wechat18257963886

     Facebook:0086 18257963886

     Whatsapp:0086 18257963886


  • QR CODE
  • facebook